Clean plumbing is not so much a question of aesthetics as it is a question of hygiene.
The only problem is that fighting urinary stones, rust and limescale takes a lot of time and, of course, effort.
If you want to fix the situation, try the simple method described below.
In addition to the fact that it does not require large financial costs, it is also able to remove contamination without the use of aggressive chemicals.
Instead, you will need the following products at hand: baking soda, citric acid and vinegar.
It turns out that a combination of the listed ingredients can effectively remove dirt and give the cleaned surface the desired whiteness.
The procedure for preparing a cleaning solution is not complicated.
In 2 liters of water (it is better to take warm) you need to dissolve 3 tablespoons of soda. After you have thoroughly mixed the contents of the container, pour it into the toilet.
After 15 minutes, pour 2-3 tablespoons of citric acid inside, paying special attention to the dirtiest places.
To enhance the effect, sprinkle the lemon with vinegar: as a result of the reaction, you will be able to remove even old rust stains.
Wait for about 20 minutes, then thoroughly scrub the surface of your “white friend” with a brush and drain the water.
A snow-white surface awaits you, on which yellowness or plaque will not be visible even under a magnifying glass.
